For adults 18 and older. Ordering is not open yet.

Sleeve Studio

Step 3 of 3

Prep and pour

One sleeve takes about 30 minutes of work and 4 hours of waiting.

Pipe closed with the plug and taped; brushing a thin film of petroleum jelly onto the mandrel

1Prep the mold

  • Cut the PVC pipe to 200 mm (7-7/8 in). Sand the cut ends flat.
  • Coat the mandrel, the plug and the inside of the pipe with a thin film of petroleum jelly (Vaseline works great) or a mold release spray. A thick coat smears into the sleeve.
  • Push the plug into one end of the pipe and wrap the joint with painter's tape.
  • Keep latex gloves and sulfur clay away: platinum silicone will not cure against them. Use nitrile gloves.
Weighing part A and part B into a cup on a kitchen scale

2Mix the silicone

  • Stir part A and part B in their own jars first.
  • Weigh equal amounts of A and B into a cup. One sleeve takes about 200 g (7 oz) in total; the exact grams are in your order card.
  • Mix for 3 minutes, scraping the sides and bottom, then pour into a second cup and mix 1 more minute.
  • Optional, but a big help: put the mixed cup in a vacuum chamber until it rises and falls. Only vacuum the cup, never the filled mold.
  • Work in a room above 65 F (18 C). A cold room slows the cure.
Pouring a thin stream of silicone into a window in the mandrel's hat, the hat resting on the pipe

3Pour

  • Brush a thin coat of silicone into the mandrel's pits and grooves.
  • Lower the mandrel into the pipe until its end sits in the plug and its hat sits on the pipe.
  • Pour a thin stream into one of the hat's windows. The air leaves through the others.
  • Stop when the mix stands in every window. Tap the pipe 20 times, wait 5 minutes, and top up.
Pulling the mandrel out of the cured silicone by its hat

4Cure and demold

  • Leave it standing for 4 hours at room temperature.
  • Peel off the tape and pull the plug.
  • Grip the hat and pull the mandrel out. On twisting designs, turn it as you pull.
  • Push the sleeve out of the pipe from the closed end. Trim the thin ring at the rim.
  • Wash the sleeve with mild soap and warm water, let it dry, and dust it lightly with cornstarch.